vacuum fume extractor classification The main reason for the bad shaking mechanism is the joint bearing. In practice, if the hole of the joint bearing is worn long, the rocker rod hardly moves when the rocking motor is running. The reason is that when designing this mechanism, the rocking time is stipulated to be 30s, so this time is sufficient. There are two joint bearings in the rocking mechanism, the above one is connected with the motor eccentric, the following one is connected with the rocker crank, and the bearing connected with the eccentric wheel runs in a circular motion, while the other only does reciprocating motion. Accordingly, the above bearing connected with the eccentric wheel has a large operating amplitude, and it is also easy to heat. When the continuous running time is less than 30s, slight heating is not a problem, if the running time is extended to more than 1min, it will heat, will seriously burn the bearing, so in the selection of vacuum fume extractor classification can not arbitrarily change the shaking cleaning time.

What are the structural features of vacuum fume extractor classification? Here is a detailed introduction for you:

1. The fan parts adopt the imitation centrifugal fan, with large air volume, high wind pressure, hard fan characteristic curve, and adopt noise reduction measures, and the noise is small when used.

Second, the filter parts are made of 208 industrial polyester twill flan cloth filter, each bag is equipped with spring steel wire mesh, the filter effect is good, the replacement of the filter bag is convenient, and the service life is good.

Third, the cleaning mechanism of the filter component is to use the motor to drive the eccentric wheel, and the connecting rod makes the cloth bag shake and stick to the dust on the outer surface of the filter bag. The control device is divided into two kinds: automatic control and manual control. Automatic control means that when the fan is working continuously, the flight cleaning mechanism will automatically vibrate the ash at a regular time. Manual control means that the flight cleaning mechanism will automatically work after the fan stops, and it will automatically stop after tens of seconds. The dust cleaning motor can also be started at any time according to the need.

Fourth, the filter component is equipped with a wide and sealed folding access door to repair and remove the filter when necessary.

5. Dust collector components adopt a suction structure, which is convenient for dust.

6. The air inlet interface on the upper side of the dust collector can be folded down when needed, so as to increase the use of the air inlet area.

vacuum fume extractor classification There are 16 kinds of specifications, divided into A, B two types. Type A is equipped with ash bucket drawer, type B is not equipped with ash bucket drawer. The lower part of the flange; It is directly connected by the user to the dumping port of the folding bin, the mixing warehouse, the sandblasting box, the belt transportation turning point and other dust collecting equipment on the spot, and the dust is directly recovered.

vacuum fume extractor classification can be manufactured according to the actual needs of design units or users.

vacuum fume extractor classification includes frame, motor, fan, electric control box, dust filter bag, door, vibration motor, vibration mechanism, hopper, dust hopper, dust door and dust filter frame, the frame includes the upper shell and the lower shell, the motor and fan are arranged in the upper shell, The dust filter bag, the hopper and the dust receiving hopper are arranged in the lower shell, the dust filter is installed between the upper shell and the lower shell, the dust filter bag is connected with the dust filter frame, the elastic sealing pad is arranged between the frame and the dust filter frame, the vibration motor is connected with the dust filter frame through the vibration mechanism, the air inlet is arranged on the side of the lower shell, the air outlet is arranged above the upper shell, the motor and the vibration motor are respectively connected with the electric control box. The dust collector has the characteristics of compact structure, easy operation, low noise, good dust removal effect, and can be directly applied to small places and laboratories.

vacuum fume extractor classification https://www.kaisenfilter.com/Have-you-ever-wondered-how-a-Vacuum-Fume-Extractor-works.html